Safety information

Operating environment

  • Install in clean, dust-free and insect-free places.
  • Operating temperature: -25 ~ 75°C (-13 ~ 167°F).
  • Humidity range is 10% to 95% (non-condensing), Use the device in a dry environment.
  • Away from heat sources and direct sunlight.
  • It must not be exposed to acid fumes, salts and other chemicals.
  • Device not to be used in places where risk of gas explosion is there.

   Use in inappropriate conditions may damage the device or shorten its life cycle.

Electrical and power supply safety

  • The device is powered with voltage range of 8-36V DC, voltage up to 24V DC is considered safe. Be careful especially while supplying higher voltages to power on device.
  • The device has an ability to control the output with the mains voltage of 230V. In such cases, it is especially necessary to observe the safety rules and must follow it during installation.
  • Use the supplied power adapter or a good quality certified power adapter with the correct supply voltage range and sufficient power as mentioned in datasheet.
  • Use only approved accessories suggested by manufacturer.

   Make sure to install device by a person with qualification and appropriate knowledge.

Malfunctioning and damaged device

  • Do not disassemble the device in any case, instead contact the manufacturer/supplier.
  • Only qualified personnel must service or repair the device or its accessories.
  • If water or any liquid got into the device, or if it looks mechanically damaged make sure not to power it up in any case, instead contact authorized support team or service center.

Radio frequency exposure

This device has been designed and manufactured not to exceed radio frequency energy emission limits set by regulatory agencies. To comply with RF exposure guidelines, the device must be used at least 20 cm away from a person's body.

Failure to follow these instructions may result in exceeding the applicable RF exposure limits. This only applies to models with a built-in LTE modem.

What to do and what not to do

  • You are solely responsible for the use of the device and any consequences of its use.
  • Do not store or use the device in harsh environments such as dust, gases, oils, chemical vapors and damp places.
  • Do not throw the device and its accessories anywhere in environment, Handle it with care.
  • If any need to dispose the device, check your local regulations for recycling and disposal of electronics and must follow the same.
  • The device heats up during operation, Hence, ensure proper ventilation to device.
  • Route power, Ethernet, and antenna cables properly so that they cannot be accidentally pulled out.
  • The device should be used and kept away from small children.